Cleaning/Inspection - TM-9-2815-224-34-P0326

TM9-2815-224-34&P

Fuel System Maintenance Instructions (Cont)

13-2. FUEL PUMP REMOVAL/REPAIR/INSTALLATION (CONT).

(4) Remove eight screws (7), lockwashers (8),

and cover (9) from housing (10).

(5) Remove drive shaft and gear assembly (11).

Do not remove gear from- shaft.

(6) Remove drive shaft and gear assembly (12).

Do not remove gear from shaft.

(7) Remove plug (13), gasket (14), spring (15),

pin (16), and valve (17) from housing (10).

(8) Remove fuel pump holder from vise. Install

housing (10) in vise.

NOTE

Tag and mark how oil seals are installed, Install

new seals with lips pointing in same direction.

(9) Remove two oil seals (18 and 19) from

housing (10).

(10) Mark location and remove two pipe plugs (20)

from housing (10).

c.Cleaning/Inspection

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful

vapors, and are harmful to skin and clothing. To avoid injury or death, keep away

from open fire and use in well-ventilated area. If adhesive, solvent, or sealing

compound gets on skin or clothing, wash immediately with soap and water.

(1) Inspect all parts for damage. Replace damaged parts.

(2) Inspect mating surfaces of housing and cover. Mating surfaces must be flat and smooth and fit

together tightly.

(3) Inspect valve. If valve is lightly scored, use crocus cloth to remove marks. If marks cannot be

removed with crocus cloth, replace valve,

13-4