 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Fuel Injector Maintenance Instructions (Cont)
12-2. FUEL INJECTOR REMOVAL/INSTALLATION (CONT).
a. Removal.
NOTE
This procedure tells how to remove
and install one injector. Remove and
install other seven injectors in same
way.
(1) Loosen retaining nut (1) and
injector control rack lever adjusting
screw (2).
(2) Slide injector control rack lever (3)
away from injector control rack (4).
(3) Mark and remove screw (5), convex
washer (6), and clamp (7).
NOTE
Injector tube hole in cylinder head
must be covered to keep dirt out.
(4) Remove injector (8).
WARNING
q Compressed air used for cleaning
purposes will not exceed 30 psi
(207 kPa). Use only with effective
chip guarding and personal
protective equipment
(goggles/shield, gloves, etc.).
When working with fuel, post signs
q
that read "NO SMOKING WITHIN
50 FEET". To avoid serious injury
or death, keep fuel away from open
fire and keep fire extinguisher
within easy reach when working
with fuel.
(5) Clean exterior of each injector (8)
with diesel fuel and dry with
compressed air.
12-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals