 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Engine Brake Retarder Maintenance Instructions (Cont)
NOTE
Solenoid valve is used on supply
housing only.
There are three models of
solenoid valves. Models A and B
use a screw and lockwasher to
attach the solenoid wire, while
Model C has a spade (push-on)
type connector. If a Model A or B
solenoid must be replaced with a
Model C solenoid, the housing
must be changed also. Refer to
TM 9-2320-279-24P for proper
identification of parts.
Remove solenoid valve (7) from supply
(3)
housing (3).
Remove two seals (8 and 9) from solenoid
(4)
valve (7).
Remove seal (10) from supply housing (3).
(5)
Remove nut (11) and setscrew (12) from
(6)
supply housing (3).
WARNING
Slave piston is retained by spring under
compression. Spring can be discharged and
cause personal injury.
Turn supply housing (3) over and use
(7)
press to hold slave piston spring (13)
and spring retainer (14) in place.
Remove retaining ring (15).
(8)
Slowly release force from spring
(9)
retainer (14) and release slave piston
spring (13).
Remove spring retainer (14),
(10)
spring (13), and slave piston (16) from
supply housing (3).
11-7
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals