 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2815-224-34&P
Flexplate and Flywheel Housing Maintenance Instructions (Cont)
5-3. FLYWHEEL HOUSING AND REAR OIL SEAL REMOVAL/INSTALLATION (CONT).
Install base on end of crankshaft (7) with two
(45)
guide studs. Tighten guide studs until base
is firmly against end of crankshaft.
Install spacer over center screw of base.
(46)
Install installation tool housing, with sleeve
(47)
(56) and oversize oil seal (57), onto guide
studs with thrust washer and nut. Tighten
nut by hand until snug. Further tighten nut
until installation tool housing is seated
against base.
Remove installation tools from end of
(48)
crankshaft (7).
5-18.2 Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals