Installation-continued - TM-9-2815-224-34-P0136

Crankshaft Maintenance Instructions (Cont)

4-5. MAIN BEARING AND CRANKSHAFT REMOVAL, REPAIR, AND INSTALLATION (CONT).

(26) Install seven screws (18) and

washers (19). Tighten screws finger

tight.

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give

off harmful vapors, and are harmful

to skin and clothing. To avoid injury

or death, keep away from open fire

and use in well-ventilated area. If

adhesive, solvent, or sealing

compound gets on skin or clothing,

wash immediately with soap and

water.

(27) Apply small amount of compound No. 2 to threads of ten screws (15) and surfaces of

stabilizers (16 and 17).

(28) Install ten screws (15).

(29) Strike bearing caps (12) with soft-face hammer.

(30) Tighten eight screws (15) on four front bearing caps (12) to 50 lb-ft (68 N-m) starting with the

middle two caps.

(31) Strike bearing caps (12) with soft-face hammer and tighten eight screws (15) to 110 lb-ft

(149 N-m).

(32) Strike bearing caps (12) with soft-face hammer and tighten eight screws (15) to 230 to 240 lb-ft

(312 to 325 N-om).

4-26