Removal. - TM-9-2815-224-34-P0083

TM 9-2815-224-34&P

Cylinder Head Maintenance Instructions

a. Removal.

NOTE

Left and right banks are

different. Left bank has

three screws. Right bank

has only two screws.

Bracket shown being

removed from left bank.

(1) Remove two

screws (1),

lockwashers (2),

and washers (3).

NOTE

Some engines have a fuel

modulator air supply hose

on the left bank. For

engines with fuel modulator

air supply hose, perform

steps (1.1) and (2.2). For

engines without fuel

modulator or for right

bank, perform step (2).

Disconnect hose (3.1) from elbow (3.2).

(1.1)

Remove screw (4), lockwasher (5), hose (3.1), clamp (3.3), and bracket (6).

(1.2)

Remove screw (4), lockwasher (5), and bracket (6).

(2)

Remove two screws (7), lockwashers (8), and hose clamp (9).

(3)

Remove engine lifting bracket (10).

(4)

Remove two screws (11) and

(5)

washers (12) from crossover

tube (13) at rear of engine (14).

NOTE

Tag wire before cutting or

disconnecting.

Some brake retarder wires must

be cut at butt connector. Others

can be disconnected and do not

need to be cut.

(6)

Disconnect brake retarder

wire (15) from cylinder head

(31) or cut wire at butt

connector.

3-35

Change 2