 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 CYLINDER HEAD REPAIR (CONTINUED)
NOTE
Make sure push rod shields fit into cylinder head
indents when installing cylinder head.
E
Place cylinder head (7) on cylinder block (5).
F
Coat cylinder head bolts with anti-seize compound (item 2,
Insert short head bolt (8) and washer (9) in each end of
cylinder head.
H
Tighten two bolts (8) just enough to hold head gasket.
-o
push rod shields.
9
Install connector (19) and connect oil line (20) to connector (19).
I
Insert four short bolts (10) and four washers (11).
J
K
and washer
in center of cylinder head.
Insert long bolt
L
Snug six short bolts (8 and 10).
M
Snug long bolt (12).
NOTE
Do not overtighten breather standpipe.
N
Install breather standpipe (14).
o
Place push rod guide (15) over breather standpipe
P
Insert and snug four long bolts (16).
3-47
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals