 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
19. REMOVE TWO LOOP CLAMPS (1).
a. Using wire-twister pliers, remove
and discard two Iockwires (2).
b. Using 3/8-inch drive ratchet handle
20. ATTACH FIXTURE REMOVAL
and 5/32-inch socket wrench attach-
ASSEMBLY (6).
ment, remove screw (3), bolt (4), and
a. Install two screws (7) in screw
spacer (5). Discard screw and bolt.
holes (8) in hydraulic assembly (9).
c. Spread open and pull off two
b. Tighten two screws (7).
clamps (1).
21. POSITION TRANSMISSION LEFT
SIDE UP.
WARNING
Hanging loads could kill or
injure you. Keep away from
hanging loads and overhead
equipment.
CAUTION
Do not contact hoses with hydraulic assem-
b l y w h e n l i f t i n g f r o m transmission.
Damage to equipment can occur.
NOTE
Race may be lifted by hand for removing two
screws that are close to main housing.
22. REPAIRER AND HELPER REMOVE LEFT-
H A N D HYDRAULIC ASSEMBLY (9).
a.
Remove one long bolt (10), seven short
bolts (11), and eight washers (12).
Attach lifting device (13) to removal
b.
assembly (6) and lift out hydraulic
assembly (9).
GO TO NEXT PAGE
4-363
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals