 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
3. REMOVE PLAIN ENCASED SEAL (1).
a. Using screwdriver, carefully pry
seal (1) away from output housing (2).
b. Remove seal (1) and gasket (3).
Discard gasket.
WARNING
Retaining ring is installed
under high tension. Use care
when removing and installing
retaining ring. Personnel can
be injured. Always wear
goggles.
CAUTION
Do not scratch carrier shaft surface when
removing retaining ring. Equipment can
be damaged.
4. REMOVE TAPERED CONE
AND ROLLERS (4).
a. Using retaining-ring pliers, remove
retaining ring (5) and thrust washer (6).
Discard thrust washer.
b. Remove cone and rollers (4).
5. INSPECT CONE AND ROLLERS (4).
a. Inspect cone and rollers (4) for damage.
See TM 9-214.
b. Replace cone and rollers (4) if damaged.
GO TO NEXT PAGE
4-295
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals