 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
15. INSPECT FOUR PADS (5) ON
CAUTION
PISTON ASSEMBLIES (6).
Do not pry against clutch disk. Damage
to equipment can occur.
a. Inspect four pads (5) for damage. See
14. REMOVE BRAKE (1).
b. If pads (5) are not damaged, go to
a. Remove six self-locking bolts (2),
step 16. If any pad is damaged, replace
washers (3), and oil baffle (4). Discard
all piston assemblies (6), See task
bolts.
R E P A I R LEFT-HAND SINGLE
b. Using pry bar, pry off brake (1).
DISK BRAKE, page 4-262.
16.1 CHECK DISK (7).
a.
Using micrometer caliper set,
measure thickness of disk (7) in
three places.
b.
Replace disk (7) if thickness is
16. INSPECT CLUTCH DISK (7) ON
less than 0.150 inch (3.81 mm).
SPUR GEARSHAFT (8).
c.
Using flat surface and feeler gage,
Remove disk (7) and inspect both
a.
check disk (7) for warpage. Check
sides for damage. See page 2-5.
inside and outside edges in three
places.
b.
If disk (7) is damaged, replace it
and go to step 17. If not, go to
d.
Replace disk (7) if warpage is
step 16.1.
greater than 0.010 inch (0.25 mm).
4-258
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals