|
|
TM 9-2520-270-34
29. CHECK CLEARANCE (2) OF
CLUTCH DISK (1).
a. Measure clearance (2) between clutch
disk (1) and four brake pads (3).
b. If clearance (2) is 0.021-0.060 inch
(0.53-1.52 mm), go to step 31. If not,
28. INSPECT CLUTCH DISK (1) FOR
go to step 30.
DAMAGE. See page 2-5.
a. If disk (1) is damaged, go to
30. REPLACE LEFT-HAND SINGLE
step 30. If not, go to step 29.
DISK BRAKE, page 4-255.
NOTE
When Installing parts with splines or gear teeth,
make sure that mating parts mesh properly.
31. INSTALL SPUR GEAR (4) WITH
STRAIGHT SHAFT (5) AND THRUST
WASHER BEARING (6) IF REMOVED.
a. Install bearing (6). Two tabs on
bearing go into two holes (7) in
left-hand hydraulic assembly (8).
b. Install gear (4) with straight shaft (5).
Gear goes all the way into differential
carrier assembly (9).
4-226
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |