 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
WARNING
Do not handle hot or cold
parts without protective
gloves. Personnel can be
injured.
52. INSTALL CUP (1) IN RETAINER (2),
CAUTION
IF REMOVED.
Only top surface of gears must be painted.
Paint on side surface of teeth where they
a. Using dry ice, cool cup (1) for
mesh can cause damage to equipment.
approximately two hours.
53. PAINT TEETH (3) ON BEVEL
b. Using oven, heat retainer (2) to
GEAR (4) AND PINION (5), IF
270 -300 F (132 -149 C).
NOT ALREADY PAINTED.
c. Wearing gloves, slide cup (1), smaller
a. Paint top of tooth (3) stamped with X
diameter opening first, into retainer (2)
on bevel gear (4).
fully seating cup against retainer
shoulder.
b. Paint tops of two teeth (3) marked with
X on pinion (5).
d. Let parts return to room temperature.
NOTE
Actual setting distance is stamped on gear
e n d of bevel gear. Stamped number reads
S.D.X.XXX.
54. OBTAIN DIMENSION A.
a. Record setting distance (6) stamped
SETTING DISTANCE
------ INCH
on bevel gear (4).
1.720 INCH
b. Subtract 1.720 inches (43.7 mm) from
S T E P 5 4 D I M E N S I O N A = INCH
setting distance (6).
c. Record result as dimension A.
Change 1
4-104
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals