 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-27-34
INSTALL
6. CHECK HOUSING BORE (1).
a. Using micrometer caliper set and
NOTE
telescoping gage set, measure
Piston is installed with open end up.
diameter of housing bore (1).
7. INSTALL PISTON (3), BOTTOM
b. If measurement is greater than
HELlCAL SEAT (4), SPRING (5),
1.5015 inches (38.138 mm), return
AND TOP HELICAL SEAT (6).
reassembled housing (2) to depot.
8. INSTALL NEW GASKET (7).
9. INSTALL PRIORITY VALVE COVER (8).
a. Aline holes in priority valve cover (8)
with holes in new gasket (7).
b. Using 3/8-inch drive brace handle and
7/16-inch socket, install two new lock
washers (9) and two long screws (10)
in holes (11). Install each screw
evenly one turn at a time.
10. USING 3/8-INCH DRIVE TORQUE
WRENCH, EXTENSION, AND
7 / 1 6 - I N C H SOCKET, TORQUE
TWO SCREWS (10) TO 85-95 in-lb
(98-109 cmkg).
GO TO NEXT PAGE
4-63
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals