 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
CAUTION
Do not remove encased seal unless cover is
properly blocked to prevent bending. Damage
to equipment can occur.
2. REMOVE PLAIN ENCASED SEAL (1).
a. Position cover (2) on three
2- by 4- by 6-inch wood blocks (3).
b. Fit small end of oil seal replacer (4)
into seal (1).
c. Using plastic-faced hammer, tap
seal (1) from cover (2) and discard
seal.
INSTALL
CAUTION
Do not install seal without properly blocking
cover. Damage to cover can occur.
3. POSITION COVER (2).
a. Position cover (2) on one 2- by
4- by 6-inch wood block (3)
4. INSTALL NEW SEAL (1).
a. Coat inside of new seal (1) with
transmission oil.
b. Fit large end of oil seal replacer (4)
into new seal (1).
c. Coat outside of seal (1) with sealant
c o m p o u n d . Using plastic-faced
hammer, tap seal into cover (2).
GO TO NEXT PAGE
3-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals