INSTALL TRANSMISSION ON TIP-OVER STAND WITH TRANSMISSION MOUNTING PLATE KIT

TM 9-2520-270-34

INSTALL TRANSMISSION ON TIP-OVER STAND WITH TRANSMISSION

MOUNTING PLATE KIT

1 . REPAIRER AND HELPER INSTALL

TIP-OVER STAND FIXTURE (1) ON

TIP-OVER STAND (2).

a. If fixture (1) is not on stand (2),

go to step 1b. If fixture is attached

to stand, go to step 2.

b. (H) Position fixture (1) on stand (2)

and aline screw holes. Rotate

adapter (3) as necessary.

c. Install six screws (4).

2 . USING 1/2-INCH DRIVE TORQUE

WRENCH, TORQUE SIX SCREWS (4)

TO 130-150 ft-lb (18-21 mkg).

WARNING

Failure to properly secure the

transmission can cause injury

to personnel or damage to

transmission.

3 . REPAIRER AND HELPER INSTALL

TRANSMISSION (5) ON TIP-OVER

STAND (2) WITH FIXTURE (1).

a. Using lifting device (6), position

transmission (5) so six holes (7) on

front of transmission aline with six

holes (8) in fixture (1).

b. (H) Install six screws (9).

USING 1/2- INCH

WRENCH, TORQUE SIX SCREWS (9) TO

130-150 ft-lb (18-21 mkg).

GO TO NEXT PAGE

2-149