|
|
TM 9-2520-270-34
CHAPTER 1
INTRODUCTION
Section
1.
GENERAL
INFORMATION
SCOPE
This manual is for use in performing Direct and General Support Maintenance on the Hydromechanical
Crossdrive Transmission, HMPT 500 and the transmission container assembly. For operational
troubleshooting, tests, and adjustments, refer to the Organizational Manual TM 9-2350-252-20-1 and
the System Manual TM 9-2350-252-34-1.
MAINTENANCE FORMS, RECORDS, AND REPORTS
Department of the Army forms and procedures used for equipment maintenance will be those
prescribed by DA PAM 738-750, The Army Maintenance Management System (TAMMS).
PREPARATION FOR STORAGE OR SHIPMENT
See Chapter 2 of this manual for directions for preparing the transmission for storage or shipment in the
container.
ADMINISTRATIVE
STORAGE
See TM 740-90-1 for the requirements for administrative storage of Army material.
NOMENCLATURE CROSS REFERENCE LIST
This listing includes nomenclature cross references used in this manual.
OFFICIAL
NOMENCLATURE
COMMON NAME
Hinged handle
Breaker bar
Shipping/storage container
Container
Liquid gage rod-cap
Dipstick
Screw-thread inserter
Drive wrench
Insert wrench
Drive wrench
Safety glasses
Goggles
Hand hammer
Plastic-faced hammer
Threaded insert remover
Removal tool
Screw-thread remover
Removal tool
Metal seal ring
Shaft seal
Retaining ring
Snap ring
Scrubbing soap
Soap
Spring resilency tester
Spring scale
Insert tool swage
Swage tool
Insert swage
Swage tool
Overhaul stand
Tip-over stand
Hydromechanical Crossdrive
Transmission
Transmission Model HMPT 500
Lubricating oil, engine
Transmission oil
1-1
Change 3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |