Corrective Action Block

TM 9-2520-270-34

Corrective Action Block

A corrective action block lists actions to be performed to replace or repair a faulty item. Do NOT

perform the actions until directed to do so at the end of the inspection tree. Record these actions on

DA FORM 2404.

Legend to Example Above

This identifies the block as a corrective action block. The actions listed in

this block must be recorded on DA FORM 2404.

This tells you to refer to a specific task to replace damaged components.

It is used when the component to be replaced is not covered in a repair

task.

This is a portion of a task to be performed. When you perform this task,

you will do only the task steps in the R E M O V E element of the task.

This tells you to perform an entire task. It does not reference a specific

task element. You will do all elements in the task mentioned in this step.

This is used to tell you what task you will use when you are directed to

perform a task element.

There is one other type of corrective action block that you will see. Below is an example of the

other type of corrective action block.

L e g e n d to Example Above

T h i s tells you to obtain a new component (or assembly) from supply.

There is no task reference. Do NOT install this new component. You will

b e directed to install the component at some other point in the tree.

T h i s tells you what to do with a component that must be repaired at

depot. You will fill out DA FORM 2407 giving any information that might

a i d in the repair of the component.

Change 2