Install gasket

TM 9-2520-249-34& P

brake apply rotating cam. Repeat the adjustment bolt

procedure and torque check on the right side.

122 Install left and right gaskets (1 and 6) and brake

120 Install gasket (2) and steer valve body assembly

adjustment covers (2 and 5). Secure each

(3) over guide bolts (1). Remove the guide

cover with two 3/8-16 x 23 3/4-inch bolts (3) and

bolts.

three 3/8-l6 x 1 3/8-inch bolts (4), five plain

washers and five lock-washers. Refer to FO-15

for torque and proper sequence of tightening

these bolts.

121 Install twenty-six 3/8-16 x 4-inch bolts (1), 24

plain washers and 24 lockwashers. Refer to

FO-15 for torque and proper sequence of

tightening these bolts. With all the left brake

components in the fully-released position, screw

adjustment bolt (6) in until it lightly contacts the

brake apply cam (on underside of the top cover

(5). Tighten locknut (4) against lug (3) so that

123 Install two 3/8-16 x 4-inch, headless guide bolts

the bolt and nut will remain in place if the power

(8) in the converter housing mounting pad on

train is run before brakes are given the final

the bevel gear housing. Install gasket (7) over

adjustment. Using adapter (2), (1, table 3-1) on

the guide bolts and retain it with oil-soluble

the brake apply shaft, apply torque to check for

grease. Attach sling (4) (26, table 3-1) to the

freedom of movement of the

converter housing assembly and position the

converter housing for installation on the bevel

gear housing.

8-41