 |
|||
|
|
|||
|
Page Title:
Install two 3/8-16 x 1 3/4-inch bolts |
|
||
| ||||||||||
|
|
 TM 9-2520-249-34&P
gear must spline onto the cross shaft,
the sun gear must mesh with the
carrier pinions, and the reverse-range
ring gear brake hub internal teeth must
mesh with the pinions.
30. Install twenty-four 3/8-16 x 1 3/4-inch bolts (1)
24 plain washers and 24 lockwashers. Tighten
the bolts to 27 to 32 pound feet torque. Using
holder assembly (2), (16, table 31) lock output
drive gear (4). Tighten bolt (3) to 200 to 225
pound feet torque.
29. Install two 3/8-16 x 1 3/4-inch bolts (5) 180
degrees apart, and carefully draw output
housing assembly (4) against bevel gear
housing (3). When the output housing assembly
is seated against the bevel gear housing,
remove two bolts (5) and guide bolts ill.
Remove lifting sling (2), (25, table 3-1).
31. Using a blunt rounded-tip chisel, bend
lockwasher (1) against a flat side of bolt head
(2), opposite hole (3). Using a punch, bend
washer (1) down into hole (3) of lock plate (4).
8-15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals