 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPAIR SINGLE DISK PIVOT STEER BRAKE ASSEMBLY -- Continued
0030 00
NOTE
On some early brake assemblies, the lining is held in place with two rivets and two clips.
Remove and discard rivets, if installed.
4.
Remove retaining ring (3), spacer (4), and packing (5) from release unit nut (6). Discard retaining ring and packing.
5.
Repeat Steps 1 - 4 above for other housing.
NOTE
If vehicle has optional pivot steer brake, do Steps 6 - 9.
6.
Remove shoulder screw (7) from brake housing (8). Remove packing (9) from screw. Discard packing.
7.
Remove release unit piston (10) with attached brake lining (11) from housing (8) using an arbor press. Remove packing
(12) from piston. Discard packing.
8.
Remove release unit nut (13) from housing (8) using remover and replacer tool. Remove packing (14) from release unit
nut. Discard packing.
NOTE
Turn remover and replacer tool in the clockwise direction.
9.
Separate brake lining (11) from piston (10) using brake and clutch reliner.
0030 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals