Install oil seal

TM 9-2520-238-34

REPAIR OUTPUT SHAFT ASSEMBLIES -- Continued

0024 00

NOTE

Steps 14 - 23 apply to left output shaft assembly.

If serrated lockring screw thread insert was removed in page 0024 00-2, do Steps 1 - 3.

14. Thoroughly clean mating surface of new encased oil seal (1) with cleaning compound.

15. Apply thin film of sealing compound to outer edge of oil seal (1).

CAUTION

To prevent damage to encased oil seal, do not press seal beyond face of bore. After installation,

seal must be flush with outer surface.

16. Install oil seal (1) in oil seal retainer (2). Use remover and replacer (WP 0033 00, Item 24) and hammer.

0024 00-10