ASSEMBLY - TM-9-2520-238-340187

TM 9-2520-238-34

REPAIR FINAL DRIVE ASSEMBLIES A AND B -- Continued

0020 00

ASSEMBLY

NOTE

The final drive housing and cover are machined as a unit and must be retained or replaced as a

matched set.

Apply sealing compound (WP 0035 00, Item 14) to small end of pipe threads. Do not apply sealant beyond small end of

pipe threads. Do not fill leading thread. Install two pipe plugs (1) in housing (2).

If removed during disassembly, install new speedometer adapter (3) and protective plug (4) in final drive shaft (5).

Position shaft assembly on level surface on arbor press with splined end up. On chamfered surface of seal spacer (6)

nearest output shaft assembly (7), apply a coat of sealing compound (WP 0035 00, Item 16). Place spacer (6) on shaft

assembly so spacer holes are between the 3/8 inch diameter holes in shaft assembly. Using a metal tube with same

diameter as spacer (6) and arbor press, press spacer on output shaft assembly.

0020 00-7