Insert engine disconnect actuator

TM 9-2520-238-34

REPAIR TRANSFER GEARCASES A, B, AND C -- Continued

0017 00

CAUTION

To prevent damage to encased oil seal, do not press seal beyond face of bore. After installation

seal must be flush with outer surface.

17. Install new encased oil seal (13). Apply a thin even film of sealing compound (WP 0035 00, Item 12) or (WP 0035 00,

Item 13) to clean mating surface of seal. Position seal with lip toward bore. Use a flat block of wood and mallet and tap

seal in place.

18. Insert engine disconnect actuator (14) through hole in top of gearcase housing. Secure to housing bracket with washer

(15) and new cotter pin (16).

19. Insert ball bearing (17) into shift collar (18). Secure in place with new retaining ring (19).

20. Install shift collar (18) on input shouldered shaft (20). Secure with new retaining ring (21).

21. Align splines of input shaft (20) with input gear. Install input shaft with shift collar (18) aligned with actuator (14).

0017 00-18