 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-238-34
REPAIR COOLING FAN RIGHT ANGLE DRIVE C (M113A3 FOV ONLY) -- Continued
0016 00
13. Remove four cap screws (1), washers (2), packings (3), spindle assembly (4), and laminated shim (5) from housing (6).
Discard packings and shim.
NOTE
Do not attempt to remove tapered roller bearing from shaft. The bearing and shaft are a
matched set. If bearing of shaft is damaged, obtain a new shaft and bearing from supply.
14. Disassemble spindle assembly (4) as follows:
a.
Remove four cap screws (7) and washers (8).
b.
Remove shaft and bearing (9) with attached parts from bearing retaining plate (10).
15. Remove liquid sight indicator (11) and packing (12) from housing (6). Discard packing.
16. Remove pipe plug (13) from housing (6).
17. If inspection indicates identification plate (14) must be replaced, remove four drive screws (15) and identification plate
from housing (6). Discard drive screws. Record identification data for use on new plate before discarding old plate.
CLEANING
CLEAN, INSPECT, AND REPAIR
1.
Before inspection, repair, or assembly, clean all parts as described in (WP 0014 00).
2.
Inspect all parts. Refer to (WP 0014 00) for general inspection procedures. See TM 9-214 to check bearings. Check
wear limits page 0016 00-17.
3.
Repair or replace defective parts. Refer to (WP 0014 00) for general repair procedures.
0016 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals