HOW TO USE THE REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL) WITH THIS MANUAL

TM 9-2520-238-34

HOW TO USE THIS MANUAL (cont)

11. Straighten tabs on two key washers (1). Remove two cap screws (2), key washers (3) and cover (4) from housing cover.

Discard key washers.

After doing this step, you would clean the mating surface with cleaning compound and a wiping rag according to the general

cleaning procedures. In other tasks, hoses or rubber hatch seals will need to be checked for leaks. Refer to (WP 0014 00) for

general procedures.

HOW TO USE THE REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL) WITH THIS MANUAL

The RPSTL TM 9-2520-238-34P gives the National Stock Number (NSN) required to order parts use in the maintenance

WPs. To use the RPSTL to identify and order a part, do the following:

In this manual, turn to the first page of the WP to be performed.

Find Materials/Parts under INITIAL SETUP, and read the part(s) that need replacement. If required, find the illustrated

part in the WP steps.

Go to the RPSTL and find the same illustrated part. That part will have an item number assigned to it. Look this item

number up in the listing for that figure. The NSN can be found in the National Stock Number and Part Number Index

in the back of the RPSTL.

If you inspect an item and find that it is damaged, go to the RPSTL and find the SMR code for the item. If the SMR

code does not authorize you to repair the item, reassemble it and send it to the authorized level of maintenance.

vii/viii blank