Click here to make tpub.com your Home Page

Page Title: Figure 5-8. Field Service Kit and Instructions.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 746-10
INSTRUCTIONS
CAUTION: Only trained personnel shall handle unpreserved ESDS items. Disconnect all power before handling
any item.
STEPS:
1. Place unfolded workmat on table or floor near work area or service location.
NOTE: Remove all material from pockets and away from mat.
2. Attach ground cord to mat fastener A, B, or C; attach bulldog clip to mainframe, chassis, or other bare metal surface
near item to be replaced or removed. This surface must be a part of unit assembly containing item.
3. The wrist strap coil cord containing resistor, shall be attached to the same mat fastener as the ground connector A, B,
or C; adjust wrist strap over wrist against bare skin.
4. Proceed now to remove, replace, or handle the ESDS item only on the mat surface. Keep all other tools or non-
ESDS items off the mat.
5. ESDS items to be returned (e.g., condition code F) for repair or otherwise removed from the static dissipating mat
shall be packaged to prevent any further deterioration. This procedure is the only technique where the reuse of ESD
preservation material is encouraged. Place item in pouch D, made from material conforming to MIL-P-81997, type II.
Fold over opening and place in shielding bag E, made from material conforming to MIL-B-81705, type I. Fold the
opening, and place a rubber band over this shielding bag. Do not use adhesive tape. Item can now be handled as you
would any other non-ESDS item.
NOTE: Do not disassemble the field service kit until all procedures have been completed.
Figure 5-8. Field Service Kit and Instructions.
c. Wrap the item with barrier material conforming
in half and heat sealed on three sides. This becomes
the unit pack which can be handled as you would any
to MIL-B-81705, type II, or cushion sharp edges and
non-ESDS item.
extrusions with material conforming to PPP-C-1842,
type III, style A or B.
e. Place a sensitive electronic device unit pack
d. Place the wrapped or cushioned item in a bag
label (fig 5-10) on the unit pack as illustrated in figure 5-
9. In the absence of NSNs, local purchase procedures
(MIL-B-117, type I, class F, style I) made from material
shall be followed when ordering this unit pack sensitive
conforming to MIL-B-81705, type I. The bag shall be
electronic device label. When
made of one piece of material folded
5-29

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business