Section IX. MISSILE EQUIPMENT, MAJOR COMPONENTS

TM 746-10

Section IX. MISSILE EQUIPMENT, MAJOR COMPONENTS

Launcher

Relay, matrix

4-116. General

Limiter, noise

Ring assembly

Specific and detailed requirements provided by the U.S.

Load cell

Safety and arming device

Army Missile Command (MICOM) for missile systems

Loudspeaker

Scan converter

and missile system selected support items take

Magnetron assembly

Seeker section

precedence over instructions included in this section.

Matrix assembly

Self-test assembly

Microwave kit

Servomechanism

a. Missile component items (end items and

Modification kit

Servomotor

replacement assemblies or parts other than principal

Network, sensing

Shunt

items) for the purpose of this section are listed in groups

Optical assembly

according to their physical/chemical surfaces and

Simulator

configuration. Each group is categorized according to

Parameter assembly

Slip-ring assembly

the minimum method of preservation deemed necessary

Parity assembly

Speed control

to protect equipment against deterioration for a period of

Patchboard assembly

Speedgate

180 days.

Periscope assembly

Stabilizer

b. The prescribed methods and submethods of

Photoelectric cell as-

Switching unit

preservation will be accomplished in conjunction with

sembly

the fundamental principles contained in the TM 38-230-

Pneumatic test set

Telescope assembly

series of preservation and packing manuals.

Power package

Transformer

Pressurizing unit

Transmission

c. Preservation of vehicles, trailers, semi-trailers,

Printer assembly

Trimming assembly

and trailer dolliers will be per paragraphs 4-135 and 4-

Processor, signal

Tube, launcher

137.

Projector assembly

Tunnel section

Pulse selector

Turbine assembly

d. All circuit cards and items identified as ESDS

Radar set

Waveguide assembly

items shall be preserved submethod IA-8 and as

Radio set

Yoke drive assembly

specified in section XXIII of chapter 5.

Radome

Zeroing assembly

4-117. Category I (Submethod IA-14)

Missile Component Items

a. Clean category I missile items per process C-1

Accelerometer

Counter assembly

as described in TM 38-230-1.

Accumulator

Cursor

b. Accomplish drying, as required, immediately

Actuator

Damper

after cleaning by one or more of five different

Alignment fixture

Delay timer

procedures defined in TM 38-230-1 provided the item

Antipropulsion unit

Distributor

will not be damaged by the procedure.

Astig focus unit

Divider

c. Do not apply contact preservatives to category I

Autocollimator

Drive assembly

missile items.

Autopilot

Electronic components

d. Unit pack items wrapped and cushioned, as

assembly

required, submethod IA-14 per recommended

Azimuth laying set

Elevon assembly

procedures in TM 38-230-1.

Azimuth orientation

Fan

e. Accomplish packing by placing a quantity of unit

unit

packed components into a wood or plywood box.

Balance unit

Fixed memory assem-

Guidance in box fabrication, cushioning, blocking,

bly

bracing, strapping, and weight limitations is contained

Battery unit

Head assembly

inTM 38-230-2.

Beta decoder

Heat exchange

Binary assembly

Heatsink assembly

4-118. Category II (Submethod IA-15) Missile

Bolometer

Horn, waveguide

Component Items

Camera

Igniter

Adapter assembly

Alarm, temperature

Chassis assembly

Input-output assembly

Adapter, calibration

Alignment prism

Compensator

Interconnecting box

Add and subtract sub Aligning tool

Controller, pressure

Irradiance set

assembly.

Isomodulator

Junction box

Relay assembly

4-53