COLUMN ENTRIES.

TM 55-6605-263-14&P

Repair. The application of maintenance services (inspect, test, service, adjust, aline, calibrate or replace) or

other maintenance actions (welding, grinding, riveting, straightening, facing, remachining, or resurfacing) to restore

serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly, module

(component or assembly), end item, or system.

Overhaul. That maintenance effort service/action necessary to restore an item to a completely

serviceable/operational condition as prescribed by maintenance standards (i.e., DMWR) in appropriate technical

publications. Overhaul is normally the highest degree of maintenance performed by the Army. Overhaul does not

normally return an item to "like new" condition.

k. Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to a "like

new" condition in accordance with original manufacturing standards. Rebuild is the highest degree of material

maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero those age

measurements (hours, miles, etc.) considered in classifying Army equipment/components.

B-3.

COLUMN ENTRIES.

a. Column 1, Group Number. Column 1 lists group numbers, the purpose of which is to identify components,

assemblies, subassemblies, and modules with the next higher assembly.

b. Column 2, Component/Assembly. Column 2 contains the noun names of components, assemblies,

subassemblies, and modules for which maintenance is authorized.

c. Column 3, Maintenance Functions. Column 3 lists the functions to be performed on the item listed in column 2.

When items are listed without maintenance functions, it is solely for the purpose of having the group numbers in the MAC

and RPSTL coincide.

d. Column 4, Maintenance Category. Column 4 specifies, by the listing of a "Work Time" figure in the appropriate

subcolumn(s), the lowest level of maintenance authorized to perform the function listed in column 3. This figure

represents the active time required to perform that maintenance function at the indicated category of maintenance. If the

number or complexity of the tasks within the listed maintenance function vary at different maintenance categories,

appropriate "Work Time" figures will be shown for each category. The number of task hours specified by the "Work

Time" figure represents the average time required to restore an item (assembly, subassembly, component, module, end

item or system) to a serviceable condition under typical field operating conditions. This time includes preparation time,

troubleshooting time, and quality assurance/quality control time in addition to the time

B-2