Appendix B. MAINTENANCE ALLOCATION CHART

TM 55-4920-440-13&P

APPENDIX B

MAINTENANCE ALLOCATION CHART

SECTION I. INTRODUCTION

B-1. General.

a. This section provides a general explanation of all maintenance and repair functions authorized AVIM personnel.

b. The Maintenance Allocation Chart (MAC) in Section II designates overall authority and responsibility for the

performance of maintenance functions on the Production/Quality Control Shop. The application of the maintenance

function to the end item or component will be consistent with the capacities and capabilities of the designated

maintenance categories.

c. Section III lists the tools and test equipment required for each maintenance function as referenced from Section

d. Section IV contains supplemental instructions and explanatory notes for a particular maintenance function.

B-2. Maintenance Functions. Maintenance functions will be limited to and defined as follows:

a. Inspect. To determine the serviceability of an item by comparing its physical and mechanical characteristics with

established standards through examination (e.g., by sight, sound, or feel).

b. Remove/Install. To remove and install the same item when required to perform service or other maintenance

functions. Install may be the act of emplacing, seating, or fixing into position a space, repair part or module (component

or assembly) in a manner to allow the proper functioning of an equipment or system.

c. Replace. To remove an unserviceable item and install a serviceable counterpart in its place. "Replace" is

authorized by the MAC and is shown as the 3d position code of the SMR code.

d. Repair. The application of maintenance services, including fault location/troubleshooting, removal/installation,

and disassembly/assembly procedures, and maintenance actions to identify troubles and restore serviceability to an item

by correcting specific damage, fault, malfunction, or failure in a part, subassembly, or end item.

B-3. Explanation of Columns in the MAC, Section II.

a. Column 1, Group Number. Column 1 lists functional group code numbers, the purpose of which is to identify

maintenance of significant components, assemblies, and subassemblies, with the next higher assembly. End item group

number is "00".

b. Column 2, Component/Assembly.

Column 2 contains the names of components, assemblies, and

subassemblies for which maintenance is authorized.

B-1