Fixed Equipment/Components - Removal/Installation

TM 55-4920-439-13&P

3-20. Fixed Equipment/Components - Removal/Installation

3-20

This task covers: Removal/installation of fixed, equipment/components

INITIAL SETUP

Tools:

Tool Kit, Electrical Repairer, Army Aircraft, NSN 5180-00-323-4915

Personnel Required:

68F Aircraft Electrician

REMOVAL/INSTALLATION

NOTE

Permanently installed equipment or components should not be removed, however,

in the event it becomes necessary to remove, reinstall or replace fixed equipment

or shop components within the shelter care must be taken to remove all bolts, nuts

and other fasteners. All cabinets and racks are bolted to the floor and unless

isolated, are normally bolted to adjacent cabinets and/or to the wall and ceilings.

Remove bolts (1) nuts and washers (2).

2. During reinstallation of fixed equipment or

components the same hardware should be used so as to

maintain the original integrity of the shop sets. This is

especially critical in regard to items bolted to walls or

ceilings.

END OF TASK

3-30