Fixed Equipment/Component - Removal/Installation

TM 55-4920-437-13&P

3-20. Fixed Equipment/Component - Removal/Installation

3-20

This task covers: Removal/installation of fixed equipment/component

INITIAL SETUP

Tools:

Tool Kit, Prop and Rotor, NSN 5180-00-323-4904

Personnel Required:

68D Aircraft Power Train Repairer

REMOVAL/INSTALLATION

CAUTION

Permanently installed equipment or components should not be removed; however,

in the event it becomes necessary to remove, reinstall or replace fixed equipment

or shop components within the shelter, care must be taken to remove all bolts,

nuts and other fasteners. All cabinets and racks are bolted to the floor and unless

isolated, are normally bolted to adjacent cabinets and/or to the wall and ceiling.

Remove bolts (1) nuts and washers (2).

2. During reinstallation of fixed equipment or

components, the same hardware should be used so as

to maintain the original integrity of the shop sets. This is

especially critical in regard to items bolted to walls or

ceilings.

END OF TASK

3-30