TM 55-4920-433-13&P
3-24. Fixed Equipment/Components - Removal/lnstallation
3-24
This task covers: Removal/installation of fixed equipment/component
INITIAL SETUP
Tools:
Tool Kit, Hydraulic, NSN 5180-00-323-4891
Personnel Required:
68H Aircraft Pneudraulic Repairer
REMOVAL/INSTALLATION
NOTE
Permanently installed equipment or components should not be removed. However, in the event
it becomes necessary to remove, reinstall or replace fixed equipment or shop components within
the shelter care must be taken to remove all bolts, nuts and other fasteners. All cabinets and
racks are bolted to the floor and unless isolated, are normally bolted to adjacent cabinets and or
to the wall and ceiling.
1. Remove bolts (1), nuts and washers (2).
2. During reinstallation of fixed equipment or components
the same hardware should be used so as to maintain the
original integrity of the shop sets. This is especially
critical in regard to items bolted to walls or ceilings.
END OF TASK
3-37/(3-38 blank)