 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-4920-426-13&P
3-155
MAGNETO ADJUST -- Continued
3-155
ADJUSTMENT
Remove access panel.
a
b.
Remove magneto end cover.
c.
Rotate the crankshaft, use the starter, until the breaker points are wide open.
d.
Points that are badly worn or pitted should be replaced.
Pitted or pyramided points should be resurfaced with a small tungsten file.
e.
f.
Measure the breaker point opening, the opening should measure .015 inch. Use feeler gage.
Readjust the points, loosen the locking screws on the contact plate.
g.
h.
Insert screwdriver, flat tip into the adjusting slot at the bottom of the contact plate and open or close
the breaker points until the proper opening is obtained.
i.
Tighten locking screws.
Install magneto end cover.
j.
k.
Install access panel.
END OF TASK
3-214
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals