 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-4920-426-13&P
3-44
BRAKE SYSTEM REPLACE Continued
3-44
INSTALLATION (Cont)
f.
Install wheel and hub on axle.
Install outer bearing cone on axle.
g.
Install key washer on axle.
h.
i.
Install nut on axle. Tighten nut finger tight while turning the wheel clockwise, this action will seat the
bearing.
Back off the nut to "just loose" position. Hand tighten the nut, then loosen the nut until the hole in the
j.
axle lines up with the slot in the nut. Loosen the nut not more than 1/2 of flat.
Install cotter pin through slot in nut and hole in axle and spread the ends apart and around the axle.
k.
1.
Install dust cap into hub and gently tap into place.
m.
Remove jack stand.
n.
Release pressure on the floor jack and let test stand down. Apply the handbrake. Remove chocks from
wheel.
END OF TASK
3-85
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals