SPRINGS REMOVE

TM 55-4920-426-13&P

3-29

SPRINGS REMOVE

3-29

Removal

This task covers:

INITIAL SETUP

Tools

Personnel Required

68H Aircraft Pneudraulic

Jack stands or equivalent,

Repairman

Jack, one-ton, floor

REMOVAL

WARNING

Always use jack stands when equipment is raised since injury

or death can result from equipment falling.

NOTE

Axle must be raised a minimum of 16 inches above the

ground to provide enough clearance to remove the

support rod.

Jack and support axle a minimum of 16 inches above ground.

Loosen and remove upper nut.

Remove support rod.

Place jack under the test stand frame and raise frame until tension is released from the

spring.

Remove spring and spring support.

GO TO NEXT PAGE

3-61