Appendix C. REPAIR PARTS AND SPECIAL TOOLS LIST

TM 55-4920-325-14&P

APPENDIX C

R E P A I R PARTS AND SPECIAL TOOLS LIST

(Current as of 1 June 1975)

Section I. INTRODUCTION

Definition

Code

C-1. Scope.

Item procured and stocked for an-

---

This appendix lists repair parts required for op-

ticipated or known usage.

eration and performance of direct support and

general support maintenance of the Fuel Quantity

Item procured and stocked for in-

___

Gage and Indicator Test Set, P/N TF579.

surance

purpose

because

es-

sentiality dictates that a minimum

C-2. General.

quantity be available in the supply

This Repair Parts and Special Tools List is di-

systems.

vided into the following sections:

Item is not procured or stocked. If

___

a. Section Il. Repair Parts List. A list of re-

n o t available through salvage,

pair parts authorized for use in the performance

requisition.

of maintenance. Parts are listed in figure and item

NOTE

number sequence,

Cannibalization or salvage may be used

b. Section III. Special TO OlS List. Not appli-

as a source of supply for any i t e m s

cable.

source coded above except aircraft sup-

c. Section IV. National Stock Number and

port items as restricted by AR 700-42.

Part Number Index. A list, in ascending numerical

(2) Maintenance Code. Maintenance co-

sequence, of all National stock numbers appear-

des are assigned to indicate the levels of main-

ing in the listings, followed by a list, in alpha-

tenance authorized to USE and REPAIR support

numeric sequence, of all part numbers appearing

items. The maintenance codes are entered in the

in the listings. National stock numbers and part

third and fourth positions of the Uniform SMR

numbers are cross-referenced to each illustration

Code format as follows:

figure and item number appearance.

(a) The maintenance code entered in the third

C-3. Explanation of Columns.

position will indicate the lowest maintenance level

The following provides an explanation of col-

authorized to remove, replace and use the support

umns found in the tabular listings:

item. The maintenance code entered in the third

position will indicate one of the following levels of

IIIustration. This column is divided as fol-

maintenance:

lows:

Application/Exp/anation

Code

(1) Figure Number. Indicates the figure

number of the illustration in which the item is

------

Support item is removed, replaced,

shown.

used at the direct support level.

(2) Itern Number. The number used to

----

Support item is removed, replaced,

identify each item called out in the illustration.

used at the general support level.

b. Source. Maintenance and Recoverability

Codes (SMR).

(b) The maintenance code entered in the

(1) Source Code. Source codes are as-

fourth position indicates whether the item is to be

signed to support items to indicate the manner of

repaired and identifies the lowest maintenance

acquiring support items for maintenance, repair or

level with the capability to perform complete re-

overhaul of end items. Source codes are entered

pair (i. e., all authorized maintenance functions).

in the first and second positions of the Uniform

This position will contain the following main-

SMR Code format as follows:

tenance code:

C-1