 |
|||
|
|
|||
|
Page Title:
Table 5-1. Bill of Materials for Blocking and Tiedown of the M076 Rotary Tiller Mixer on the M871 Semitrailer |
|
||
| ||||||||||
|
|
 12 May 1987
TM 55-3895-359-14
Table 5-1. Bill of Materials for Blocking and Tiedown of the M076 Rotary Tiller Mixer on the M871
Semitrailer-Continued
Approximate
Item
Description
Quantity
Wire rope*
6x19, IWRC; improved plow steel; pre-formed, regular-lay; table X,
Fed Spec RR-W-410:
3/8-inch
40 feet
Clamps*
Wire rope, U-bolt clips, saddled, single-grip, steel, Crosby heavy-
duty, or equal; MIL-STD-16842:
3/8-inch
12
Thimbles
Standard, open-type: 3/8-inch
8
Nails
Common, steel; flathead; bright or cement-coated; para 3.6.11.2, Fed
Spec FF-N-105B:
(43/4-inch)
30
Protective
Waterproof paper, burlap or other suitable material
as required
material
*Suitable capacity chains and loadbinders may be substituted for 3/8-inch wire rope and clamps.
Table 5-2. Application of Material for Tiedown of the M076 Rotary Tiller Mixer on the M871 Semitrailer
Item
No. Required
Application
A
4
Chock block (fig 5-2, detail 1). Each to consist of a piece of 6-x 8-inch
lumber cut to dimensions shown. Place blocks against front and back
of each rear wheel. Secure each to trailer floor with three nails
through heel of block. Toenail each block with two additional nails
through each side.
B
2
Side block (fig 5-2, detail 2). Each to consist of a piece of 6x 6-inch
lumber cut to dimensions shown. Cover the flat end of each block with
a piece of protective material (item C), and place one block against
the inside of each rear wheel. Secure to trailer floor with three nails
through heel of block. Toenail each block with two additional nails
through each side.
C, D, E, F
8
Thimble, open-type, 3/8-inch. Place one on each M076 rotary tiller
mixer tiedown (front and back) and on each semitrailer stake pocket to
be used.
C, D, E, F
4
Wire rope, 3/8-inch. Attach in a complete loop through the thimbles on
the vehicle tiedown and through the thimble on the semitrailer stake
pocket on the same side.
20
Clamp, 3/8-inch. Secure the ends of the wire rope with three clamps
each. Space the clamps 3 3/4 inches on the rope. Secure each
thimble with one clamp.
5-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals