 |
|||
|
|
|||
|
Page Title:
Table 6-3. Application of Materials for Securing Two M88 Recovery Vehicles (Fig 6-2) |
|
||
| ||||||||||
|
|
 TM 55-2220-058-14
Table 6-3. Application of Materials for Securing Two M88 Recovery Vehicles (Fig 6-2)-Continued
Item
No. Required
Application
RT1
3
Chains. Attach chains to the right-front tiedown fitting shackle from chain anchors in D44,
D43, and C44.
LT1
3
Chains. Attach chains to the left-front tiedown fitting shackle from chain anchors in A44, A43,
and B44.
CT
6
Chains. Attach chains to the ring/shac kles in the center-front tiedown fitting shackle from
chain anchors in A42, B42, C42, D42, B43, and C43. Alternate hook placement for ring
right-left, and so forth. See figures 6-3 and 6-4. For shackle arrangement, see figure 6-6.
M88 VEHICLE NEAR POSITION NO. 1
RT2
3
Chains. Attach chains to the right-rear tiedown fitting shackle from chain anchors in D2, D1,
and C1.
LT2
3
Chains. Attach chains to the left-rear tiedown fitting shackle from chain anchors in A1, B1, and
A2.
P
6
Chains. Attach chains to the ring in the pintle from chain anchors m D3, C3, C2, B3, B2, and
AS.
RT1
3
Chains. Attach chains to the right-front tiedown fitting shackle from chain anchors in D26,
D25, and C26.
LT1
3
Chains. Attach chains to the left-front tiedown fitting shackle from chain anchors in A26, A25,
and B26.
CT
6
Chains. Attach chains to the ring in the center-front tiedown fitting shackle from chain anchors
in A24, B24, B25, C25, C24, and D24. Alternate hook placement for ring right-left, and so
forth. See figures 6-3 and 6-4.
GENERAL INSTRUCTIONS
1. M60-series tank brakes must be set. Transmission selector must be in park.
2. Turret gun must be in the aft travel position and secured to prevent movement. Turret rotation and gun-elevating
controls must be wire-tied, if feasible, to prevent movement of turret and gun.
3. Turnbuckles of front and rear chain tiedowns must be tightened at the same time to avoid disturbing the tank
position.
4. Also applicable are General Rules 4, 5, 7, 11, 15(g), 19, 19A, a nd 19C in Section 1 of the Rules Governing the
Loading of Commodities on Open-Top Cars and Trailers, published by the Association of American Railroads. These
general rules are also found in TM 55-2200-001-12.
Table 6-4. Application of Materials for Securing One M88 Recovery Vehicle Facing the Opposite
Direction from that Shown in Figure 6-1. (For location of "item, " refer to figure 6-1.)
Item
No. Required
Application
A thru D
Channels. For description, refer to paragraph 2-2c.
E
5/7
Shackles. Attach one shackle to each tow lug (three on front and two on rear of vehicle).
F
2/1
Rings. Hang one ring in towing pintle, and latch pintle closed; attach other ring/shackles to
front-center tow lug. (Use shackle to attach ring/shackles to tow lug.)
G
24
Chains. Furnished with flatcar. Apply chains between vehicle tiedown fittings and anchor
locations on the deck of the car, as shown in figure 6-1 and described below.
RT2
3
Chains. Attach chains to the right-rear tiedown fitting shackle from chain an chors in A38, A37,
and B38.
LT2
3
Chains. Attach chains to the left-rear tiedown fitting shackle from chain anchors in D38, D37,
and C88.
P
6
Chains. Attach chains to the ring in the pintle from chain anchors in A36, B36, B37, C36, C37,
and D36.
RT1
3
Chains. Attach chains to the right-front tiedown fitting shackle from chain anchors in A7, A8,
and B7.
LT1
3
Chains. Attach chains to the left-front tiedown fitting shackle from chain anchors in D7, DS,
and C7.
CT
6
Chains. Attach chains to the ring in the center-front tiedown fitting shackle from chain anchors
in A9, B9, BS, D9, CS, and C9. Alternate hook placement right-left for ring and so forth.
See figures 6-8 and 6-4. For shackle arrangement, see figure 6-6.
6-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals