Federal Supply Code for Manufacturer (FSCM).

TM 55-1935-204-24P

quantity is applicable, (e.g., shims, spacers, etc.) 4.

d. Federal Supply Code for Manufacturer (FSCM).

Special Information.

The FSCM is a 5-digit numeric code listed in SB 708-42

which is used to identify manufacturer, distributor, or

a. In the parts list some items are indented to show

Government agency, etc.

that they are a component or components of the item

under which they are indented.

e. Part Number. Indicates the primary number used

by the manufacturer which controls the design and

b. Repair parts kits and gasket sets appear as the

characteristics of the item by means of its engineering

last entries in the repair parts listing for the figure in which

drawings, specifications standards, and inspection

its parts are listed as repair parts or are listed at the end

requirements to identify an item or range of items.

of the repair parts listing for the last figure containing

parts of the kit.

f. Description. Indicates the Federal item name and

if required, a minimum description to identify the item.

c. The following publications pertain to the crane

Items that are included in kits and sets are listed below

barge and its components.

the name of the kit or set with the quantity of each item in

TM55-1935-204-12P

Operators and Organizational

the kit or set indicated in the quantity incorporated in unit

Maintenance Repair Parts and

column. When the part to be used differs between serial

Special Tools List 5. How to

numbers of the same model, the effective serial numbers

Locate Repair Parts.

are shown as the last line of the description. In the

Special Tools List, the initial basis of issue (BOI) appears

a. When National Stock Number or Part Number is

as the last line in the entry for each special tool. TMDE,

Unknown:

and support equipment. When density of equipment

(1) First. Using the table of contents, determine

supported exceeds density spread indicated in the basis

the assembly group within which the repair part belongs.

of issue, the total authorization is increased accordingly.

This is necessary since illustrations are prepared for

g. Unit of Measure (U/M). Indicates the standard of

assembly groups, and listings are divided into the same

the basic quantity of the listed items as used in

groups.

performing the actual maintenance function.

This

(2) Second. Find the illustration covering the

measure is expressed by a two-character alphabetical

assembly group to which the repair part belongs.

abbreviation (e.g., ea, in, pr, etc.). When the unit of

(3) Third.

Identify the repair part on the

measure differs from the unit of issue, the lowest unit of

illustration and note the illustration figure and item

issue that will satisfy the required units of measure will be

number of the repair part.

requisitioned.

(4) Fourth. Using the Repair Parts Listing, find

h. Quantity Incorporate in Unit.

Indicates the

the figure and item number noted on the illustration.

quantity of the item used in the breakout shown on the

illustration figure, which is prepared for a functional group,

b. When National Stock Number or Part Number is

subfunctional group, or an assembly. A ((V)) appearing in

Known.

this column in lieu of a quantity indicates that no specific