DOORS.

TM 55-1930-208-24

4-6. DOORS.

This task covers:

a. Removal

b. Repair

Installation

INITIAL SET-UP:

Tools Required:

Tool Kit, General Mechanics (Item 1, Appendix B)

Materials Required:

Gasket P/N MIL-G-23652

Pin, Cotter P/N MS24665-387

Pin, Cotter P/N MS24665-389

Washer, Lock P/N MS35338-143

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

a. Removal. (Refer to figure 4-2).

(1) Remove two cotter pins (1), two pins (2), and four washers (3).

(2) Remove toggle bolt (4) and remove door (5), gasket (6), wing nut (7), and support (8).

(3) Remove two cotter pins (9), two washers (10), two pins (11), door (12), and gasket (13).

(4) Remove two cotter pins (14), four washers (15), two pins (16), door (17), and gasket (18).

b. Repair. Repair is limited to replacing defective parts.

c. Installation.

(1) Install gasket (18) on door (17). Install door (17) and secure with two pins (16), four washers (15), and two

cotter pins (14).

(2) Install gasket (13) on door (12). Install door (12) and secure with two pins (11), two washers (10), and two

cotter pins (9).

(3) Install support (8) and secure one end with toggle bolt (4).

(4) Install gasket (6) on door (5). Install door (5) and secure with four washers (3), two pins (2), and two cotter

pins (1).

(5) Install other end of support (8), to door (5) and secure with toggle bolt (4). Installwing nut (7).

4-6