Figure 3-32. End Plate Removal Using Tool Set J6270F.

TM 55-1930-208-24

(15) Refer to figure 3-32 and install both pullers and remove the end plate.

Figure 3-32. End Plate Removal Using Tool Set J6270F.

(16) After removing one end plate (5, figure 3-31), repeat steps (13) through (15), for the other end

plate.

(17) Remove both rotors (6, figure 3-31).

(18) Support outer face of end plate on wood blocks on the bed of the arbor press.

(19) Refer to figure 3-33 and place the long end of oil seal remover and installer tool (1) down through

oil seal (2) and into bearing.

(20) Press bearing and oil seal out of the end plate (3).

(21) Repeat for other bearing and oil seal and then for other end plate.

Figure 3-33. Bearing and Oil Seal Removal Using Tool J6270-3.

3-63