Reassembly - Continued. - TM-55-1930-208-240066

TM 55-1930-208-24

(e) Lubricate the outside diameter of the governor weight (27) with engine oil; then insert the end of the weight

straight into and through the bore of the governor housing, drive gear, and base.

(f) Insert the three screws (28) through the base and thread them into the governor housing. Turn the

governor weight while tightening the screws to make sure the weight revolves freely. If a bind exists,

loosen the screws, tap the sides of the base lightly with a plastic hammer, and tighten the screws again.

Revolve the weight again and check for binding. Repeat, if necessary, until all parts rotate freely.

(g) Install the lock ring (26) in the groove in the shaft of the governor weight with a pair of snap ring pliers.

(h) Lubricate the outside diameter of the relief valve plunger and sleeve (39) with engine oil. Then, insert the

plunger inside the plunger sleeve.

(i) Place the relief valve plunger spring (36) and the plunger sleeve retaining spring (35) in the housing and

against the plunger and sleeve.

(j) Place a gasket (34) on the oil inlet plug (33), then place the plug over the ends of the springs and thread it

into the governor housing.

(k) Place a gasket (38) on the dummy hole plug (37) and thread it into the opening in the opposite side of the

housing.

(1) Clamp the bottom (square portion) of the governor housing between the soft jaws of a bench vise. Tighten the

oil inlet plug and dummy hole plug securely.

(m) Lubricate the power piston (25) with engine oil; then insert the piston, small end down, straight into the

piston bore in the governor housing, and push it in until it bottoms.

(n) Install the two terminal lever shaft bushings (24) in the housing.

(o) Lubricate one of the terminal lever shafts (21) with engine oil (item 8, Appendix C). Place the terminal

lever (20) in between the ends of the two bushings inside the governor housing; then insert the serrated

end of the shaft into the bushing in the housing with the cotter pin holes in the shaft and terminal lever in

alignment. Install a cotter pin (19) and bend the ends over against the side of the terminal lever.

(p) Install the second terminal lever shaft at the opposite side of the governor housing in the same manner.

3-49