Disassembly - Continued. - TM-55-1930-208-240062

TM 55-1930-208-24

(k) Push the terminal lever shafts out of the terminal lever and housing with the brass rod. Then, lift the

terminal lever out of the housing.

(l) Remove the terminal lever to power piston pin (23) from the piston.

(m) Remove the two terminal lever shaft bushings (24) from the housing.

(4) Remove the governor housing from the bench vise. Turn the governor upside down and remove the

power piston (25) from the housing.

NOTE

It may be necessary to tap the face of the governor housing lightly against a wood block to jar the piston out of the

housing.

(5) Place the housing, bottom side up, on a bench.

(a) Remove the lock ring (26) from the groove in the shaft of the governor weight (27) with a pair of

snap ring pliers; then remove the weight from the housing.

(b) Remove the three screws (28) securing the governor base (29) to the governor housing. Tap the

edge of the base lightly with a plastic hammer to loosen it; then, remove the base and seal ring (30)

from the governor housing.

(6) Clamp the bottom (square portion) of the governor housing between the soft jaws of a vise.

(a) Remove the oil inlet plug (33), gasket (34), relief valve plunger sleeve retaining spring (35), and

relief valve plunger spring (36) from the governor housing.

(b) Remove the dummy hole plug (37) and gasket (38) from the opposite side of the governor housing.

Insert a small brass rod through the dummy hole opening, and push the relief valve plunger and

sleeve (39) out of the housing.

inserting a 1/4 inch diameter brass rod through the shaft opening and tap the cup plug out of tile

housing with a hammer. Remove gasket (41) from the housing.

(d) Remove governor speed adjusting lever shaft seal (42) and bushing (43).

3-45