THROTTLE CONTROLS.

TM 55-1930-208-24

3-16. THROTTLE CONTROLS.

This task covers:

a. Removal

b. Repair

d. Installation

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanic's (Item 1, Appendix B)

Materials Required:

Pin, Cotter P/N MS24665-170

Washer, Lock P/N 120380

Washer, Lock P/N MS35338-44

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

a. Removal. (Refer to figure 3-16).

(1) Remove bolt (1) and lockwasher (2) securing lever (3).

(2) Remove pin (4), washer (5), spring (6), and control knob (7) from shaft (8).

(3) Loosen two set-screws (9) and remove the shaft coupling (10).

(4) Remove nut (11), lockwasher (12), and screw (13) securing control lever (14) to the governor shaft.

(5) Remove two cotter pins (15) and remove two clevis pins (16) securing control link (17).

(6) Remove nut (18), lockwasher (19), and screw (20) securing control lever (21) to control shaft (22).

b. Repair. Throttle control repairs are limited to the replacement of defective parts.

c. Installation.

(1) Secure the control lever (21) to control shaft (22) using screw (20), lockwasher (19), and nut (18).

(2) Attach control link (17) between the control levers with two clevis pins (16). Secure the clevis pins with two

cotter pins (15).

(3) Attach control lever (14) to the governor shaft with screw (13), lockwasher (12), and nut (11).

3-38