DESCRIPTION AND USABLE ON CODE (UOC) (Column (5)

TM 55-1930-202-24P

Reparable item. Condemnation and disposal not authorized below specialized repair activity

(SRA).

Item requires special handling or condemnation procedures because of specific reasons (e.g.,

precious metal content, high dollar value, critical material, or hazardous material). Refer to

appropriate manuals/directives for specific instructions.

c. CAGEC (Column (3)). The Commercial and Government Entity Code (CAGEC) is a 5-digit numeric

code which is used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.

d. PART NUMBER (Column (4)). Indicates the primary number used by the manufacturer, (individual,

company, firm, corporation, or Government activity), which controls the design and characteristics of the item

by means of its engineering drawings, specifications standards, and inspection requirements to identify an item

or range of items.

NOTE

When you use an NSN to requisition an item, the item you receive may have a different part

number from the part ordered.

e. DESCRIPTION AND USABLE ON CODE (UOC) (Column (5). This column includes the following

information:

(1) The Federal item name and, when required, a minimum description to identify the item.

(2) The physical security classification of the item is indicated by the parenthetical entry, e.g., Phy Sec

C1 Confidential, Phy Sec C1 (S) - Secret, Phy Sec C1 (T) - Top Secret.

(3) Items that are included in kits and sets are listed below the name of the kit or set.

(4) Spare/repair parts that make up an assembled item are listed immediately following the assembled

item line entry.

(5) Part numbers for bulk materials are referenced in this column in the line item entry for the item to be

manufactured/fabricated.

(6) When the item is not used with all serial numbers of the same model, the effective serial numbers

are shown on the last line(s) of the description (before UOC).

(7) The usable on code, when applicable (see paragraph 5, Special Information).

(8) In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for

each special tool, special TMDE, and other special support equipment. When density of equipments

supported exceeds density spread indicated in the basis of issue, the total authorization is increased

proportionately.

(9) The statement "END OF FIGURE" appears just below the last item description in Column 5 for a

given figure in both Section II and Section III.