Marine Coffee Maker #OT-20. (FIGURE 2- 193)

TM 55-1915-200-10

2-5.29.15. Marine Coffee Maker #OT-20. (FIGURE 2-

NOTE

193)

If tube is of a determined length, remove plug. If

the tube is not of a determined length, cut off 1/4

2-5.29.15.1. Coffee Brewing Directions. (FIGURE 2-

inch below valve spout.

193)

a. Place filter in funnel (3) and add desired amount

2-5.29.16.2. Operating Instructions.

of coffee.

b. Level the bed of coffee and insert funnel in hood

a. Turn ON circuit breaker (14, FIGURE 2-101,

guides.

Sheet 14 of 21) on power distribution panel 7B.

c. Place empty decanter (4) on bottom warmer

under funnel.

NOTE

d. Place ON-OFF switch (7) to the ON position,

During normal operation, the temperature

deflect the start switch and brew a pot of coffee.

indicator (2) shall remain in the safe or green

zone (320-44o).

CAUTION

2-5.29.17. Toaster #102-2. (FIGURE 2-195)

Do not warm coffee pots empty or with small

amounts of coffee in them. This could damage

2-5.29.17.1. Operation.

or break coffee pots.

a. Turn ON circuit breaker (4, FIGURE 2-101,

e. Turn off coffee pot by placing ON-OFF switch

Sheet 14 of 21) on power distribution panel 7B.

(7) to the OFF position.

b. Press operating lever (1, FIGURE 2-195) to

2-5.29.16. Milk Dispenser #MSF-SK-2.

activate heating elements.

(FIGURE 2-194)

c. Adjust the color selection knob (3) from light to

dark as desired.

2-5.29.16.1. Preparation for Use.

a. Place milk container (1) over valve (3) so that

NOTE

the tube lines up with the opening in the valve.

Operating levers can be manually released by a

b. Open valve (3) and feed tube through tube

separate release lever (2).

passage.

2-5.29.18. Exhaust Ventilator Control Cabinet.

CAUTION

(FIGURE 2-196)

Do not stretch tube; this may cause the tube to

2-5.29.18.1. Starting Ventilator.

pull loose from the container, causing the

a. Turn ON circuit breaker (24, FIGURE 2-101,

contents to drain.

Sheet 14 of 21) on power distribution panel 7B.

c. Remove polyethylene film covering tube.

d. Allow valve to close, pinching off the dispensing

tube.

2-518