Click here to make tpub.com your Home Page

Page Title: 1 kW Xenon Searchlight
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 55-1915-200-10
room) from open to close position.  Position will be
WARNING
shown on indicator (2).
Searchlight drum gets hot after lamp
NOTE
has been burning for some time.
Door can be closed from the remote
Avoid bodily contact with drum and
control station, but must be opened
wear gloves when handling focus
by local hand pump handle.
knob.
2-5.25. 1 kW Xenon Searchlight. (FIGURE 2-175)
(1) Push up manual focus knob (3), located
a. Lighting Lamp.
under the drum, and twist to change beam diameter.
(1) Power box (12, Sheet 2 of 2) is located in
(2) Push toggle switch (2) on powerbox down
the passageway, starboard side, near the crew's mess.
to decrease beam diameter or up to increase beam
diameter.
(2) Place power supply switch in the ON
position (11, Sheet 2 of 2).
d. Push TEST Switch button (7).  Observe that
Over-Temp light is on.
CAUTION
Do not hold in START position any
2-5.26. Aerovane Wind Transmitter. (FIGURE 2-176)
longer than necessary to start lamp.
a. Turn on circuit breaker Number 21 (FIGURE 2-
101, Sheet 7 of 21), on EP2 Power Panel in the pilot
(3) Open control box door located adjacent to
house.
searchlight. Turn the OFF/START switch (1, Sheet 1 of
2) to START. Hold long enough to start lamp, then turn
b. Adjust dimmer knob to read dials at night, or as
to straight up position.
necessary.
b. Directing Beam.
2-5.27. Portable Fire Pump.
2-5.27.1. Automatic Priming Startup.
(1) Point lever handle (5) in desired direction.
a. Clear discharge port of priming pump.
(2) Twist lever handle (5) to tilt beam up or
b. Connect red battery cable to (+) positive pole
down.
next to carburetor and black cable to (-) negative pole
(3) Secure up or down position with twist-type
next to main pump suction inlet.
knob (6) forward of lever handle (5).
c. Place OFF-START-RUN switch (3, FIGURE 2-
(4) Secure direction with clamp screw knob
177, Sheet 1 of 3) in start position.
(4) on the underside of lamp stand.
d. Advance SPEED control (7) clockwise direction,
c. Focusing Beam.
to one quarter of full throttle.
2-486

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business