REMOVAL - TM-55-1905-223-24-70096

TM 55-1905-223-24-7

(1) Reaching in watermaker from top, tag and disconnect electrical wires from AUX MCHRY MCC and magnetic starter

assembly on POWER push switch (1, FIGURE 2-18) and engine air duct (overload) heater (3).

(2) Remove two machine screws (2) and remove push switch (1) with engine air duct heater (3) attached.

e. Remove water quality water monitor assembly (7, FIGURE 2-16, Sheet 2).

(1) Remove four machine screws (3, FIGURE 2-19) at corners of water quality water monitor assembly (5).

(2) Slide water monitor assembly (5) out of main frame enough to gain access to rear of water monitor assembly.

(3) Tag and disconnect electrical wire connections from time totalizing meter (2), green indicator lamp (8) lampholder,

red indicator lamp (4) lampholder, POWER and ALARM switches (7 and 6) and terminal board (1).

(4) Remove water quality water monitor assembly (5) from main frame assembly.

Remove product flowmeter assembly (3, FIGURE 2-16, Sheet 2).

(1) Reaching in watermaker from top, disconnect two nonmetallic hoses (1 and 3, FIGURE 2-20) and hose clamps at

solenoid valve assembly and cleaning valve assembly.

(2) Remove two machine screws (4) from mounting brackets (5) and lift product flowmeter assembly (2) out of

watermaker.

g. Remove brine flowmeter assembly (9, FIGURE 2-16, Sheet 2).

(1) Reaching in watermaker from top, disconnect three nonmetallic hoses (2 and 3, FIGURE 2-21) from high pressure

regulator assembly and brine manifold assembly.

(2) Remove two machine screws (4), hexagon nuts (6), and lockwashers (5) securing meter holders (7) to main frame

and remove brine flowmeter assembly (1) from watermaker.

h. Remove high pressure regulator assembly (2, FIGURE 2-16, Sheet 2).

(1) Reaching in watermaker from top, disconnect nonmetallic hoses (5 and 6, FIGURE 2-22) from brine flow meter

assembly.

(2) Disconnect high pressure hose assembly (4) female adapter end from lower pressure vessel assembly.

(3) While supporting high pressure regulator assembly (1), remove nut (3) and flat washer (2) securing high pressure

regulator assembly (1) to metal dash panel.

(4) Lift high pressure regulator assembly (1) out of watermaker.

2-72