Section IV. REASSEMBLY AND ALIGNMENT - TM-55-1740-202-13-P0057

TM 55-1740-202-13&P

4-9. REPAIR OF DISASSEMBLED PARTS.

a. General. Replace all damaged or worn parts.

b. Hub and Drum. If the drums of hub and drum (8, fig. 4-3) are scored, resurface the drums or replace the hub

and drum assemblies.

c. Banjo Suspension Spring Assembly. If spindle portion of front plate assembly (6, fig. 4-5) is damaged, replace

the banjo suspension spring assembly.

d. Front Axle Assembly. If tie rod ends (4 and 6, fig. 4-9) or tie rods (8) are replaced, assemble parts but do not

tighten plain hex nuts (5 and 7). These nuts will be tightened when wheels are aligned.

f. Wheel Mount Shock-Absorbing Spring Assembly. If spindle or other area of knuckle (12, fig. 4-10) is worn,

replace the entire assembly.

Section IV. REASSEMBLY AND ALIGNMENT

4-10. REASSEMBLY. Assemble the transporter as follows:

a. Towbar and Chains.

(1) If it was removed, connect tubing (4, fig. 4-12) to connector (22).

(2) Attach towbar (14, fig. 4-13) to steering center arm, using towbar hinge pin (11). Secure in place with flat

washer (10) and cotter pin (9).

(3) If necessary, attach chains (8) to towbar (14), using chain shackles (5).

b. Brakes Lines and Actuator.

(1) If necessary, install damper (10, fig. 4-12), damper pin (8), and cotter pin (9).

(2) If necessary, install rear rollers (7), master pin (5), and cotter pin (6).

(3) If necessary, install front roller cover (13), front roller assembly (14), front roller pin (11), and cotter pin

(12).

4-26