Appendix E. MANUFACTURED ITEMS LIST

TM55-1730-228-13LP

APPENDIX E

MANUFACTURED ITEMS LIST

E-1. GENERAL

E-1

This appendix contains the procedures for fabricating the manufactured items you are authorized to make.

E-2. WIRING-MANUFACTURE

E-2

This task covers:

Fabrication

INITIAL SETUP

Personnel Required

MOS 63G, 1 Mechanic

FABRICATION:

(1) Cut a suitable length of wire from a spool of bulk wire.

NOTE

Be sure the wire you cut is the same gage as the wire you are replacing. Identify wire by using color coded

tape, the same color as the wire you are replacing.

(2)

Note what type and size of connector the old wire had and match them for the new wire.

(3)

Measure the length of the old wire. When cutting the new wire, add 6 in. To this length.

NOTE

If splicing a wire, use heat shrink tubing over spliced area.

(4)

Fasten the first connector splice to one end of the wire.

GO ON TO NEXT PAGE

E-1